Mutt Posted March 16, 2013 Posted March 16, 2013 Took the boat for a quick run this afternoon to dust off the cobwebs, it's a 475 Quintrex Coastrunner. Haven't had a run for about 2 months, started beautifully but was VERY hard to turn the wheel. Lowered engine down fully and managed to just turn engine, once we were up and running it slowly loosened and, all was good...is this normal? Thanks in advance....
port hacking addiction Posted March 16, 2013 Posted March 16, 2013 Hey mate is it hydraulic or cable if its cable, the metal pole bit the motor slides on when u turn just put some oil on it and turn the motor left to right till its all lubricated
Mutt Posted March 16, 2013 Author Posted March 16, 2013 It's cable, thank you so much! Will give it a go tomorrow, any oil you recommend? It's a Yamaha 2 stroke 60hp..
port hacking addiction Posted March 16, 2013 Posted March 16, 2013 No worries i use the 2 stroke oil i put in my petrol and it works fine
SargeRX8 Posted March 16, 2013 Posted March 16, 2013 Sometimes check behind the wheel, make sure the cable didn't jump a track. At one point it felt like ours seized up but it was the cable, it jumped the track and made it hard as shit to turn.
Frantic Posted March 17, 2013 Posted March 17, 2013 leaving it for a few mths is not the best , if ya can jump in it every fortnight at least and give it a good dozen or so turns from lock to lock and use those grease nipples what for amd push out all the old grease every 3 mths ,not a lost of cost for return of ease of steering ,
Mutt Posted March 18, 2013 Author Posted March 18, 2013 Thanks again to all....will oil it up and hope it does the trick!
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now