[Using old fuel]

I have replaced the fuel in my tank when I had issues with my engine

see My previous post

I have fresh 98 and oil mix in the tank and have about 10 to 15 litres of pre mixed fuel in a jerry can About 6 to 8 months old at present

is it safe to use it in 5 litre blocks in between using new 98 mix

eg

over 6 months new 98 mix then 5 litre of old mix then new again or would you just tip it out ?
 

[Replace fuel tank]

Gave the ss minnow a kick start this morning 

new 98 fuel and oil

new fuel line and bulb and a like new omc  tank I scored on Facebook for $20
she took a bit to kick over but then she purred

i let her run for 5 minutes with the water muffs on

wife was cranky as she thought I would kill the motor 
never mind

all set for a day on the water next week

[Replace fuel tank]

Thanks noel

[Replace fuel tank]

This is the new old tank fitted

[Replace fuel tank]

Thanks anyway frank

my wife found another near new omg tank on Facebook so we got it and delivered for $20

just a quick question for this

i am getting new tubing,bulb and attachments at whitworths

do I take the old bayonet fitting on the tank that’s screwed in off to clean or get some acetone on a brush to clean it all up

(Presume auto vent is built in here)

 

 

[Bilge pump question]

Thanks

i will call into whitworths tomorrow 

[Bilge pump question]

Hi all

i have a stupid question getting boat stuff checked against the NSW requirements 

my savage ranger has marine ply panels on the floor of the boat ,screwed onto the ribs
it’s basically a false floor 

does this mean I need a bildge pump?

i looked at the requirements for enclosed water and It said A bilge pump is needed if Boat has closed under floor compartments 

I wasn’t sure if a false floor by definition is an under floor compartment 
thanks in advance

greg

 

[Replace fuel tank]

Thanks Noel

I will Let you know what happens 

[Replace fuel tank]

Thanks zoran

I also watched that dude from danger marine on you tube with old fuel lines 

my son in-laws dad has a spare plastic one I can borrow so will do as you said take it for a run and see what happens

[Replace fuel tank]

Hi zoran

this problem was first trip after full service 

boat in water started ok

found a fishing spot,wife wanted to move 5 minutes later

motor wouldn’t start like it was starving of fuel continued fishing for an hour or so then tried to start it again All good trundled back to the boat ramp

motor was surging at about 3 knots in a low speed zone on way back

also leg was hot to touch when lifting and locking in place

took straight back to mechanic on way home
leg heat was thermostat issue all fixed fuel was tank wasn’t venting all painted over

mechanic suggested cracking cap on tank when going on water - Wife not agreeable to this as well as me
looked at replacing tank 23 litre stainless steel - me yes wife no

or fixing existing tank Compromise 

I looked on my tank it is a model 6
looked on google and I think it must be an auto vent 

the fuel line is also bent in a few circles from where it sat on top of tank
I presume the fuel line is old not being flexible and will replace this when my tank issue is sorted out
 

greg

 

 

 

 

 

 

[Replace fuel tank]

Hi Noel

The middle of the cap doesn’t seem to move or budge but is joined to the piece of metal on the underside of the cap in the picture a few photos up.
The  whole tank was painted silver when I got the boat Including the cap and fuel hose connection

Another query should the hose be rock hard that connects tank to engine or is that just age and if it vents when fuel line connection is on what would I look for ?

[Replace fuel tank]

Sorry Noel

I presumed you would need a spring for the breather to work on the cap

so the middle part should move a couple of mm,s to allow air in without the use of a spring?

 

[Replace fuel tank]

I asked wife about acetone but didn’t have any

i took some pictures of the cap

 

I am guessing I should have a spring in the cap somewhere?

[Replace fuel tank]

That would be great frank thanks

[Replace fuel tank]

Aha

so short term I can leave cap half on and use tank ?

[Replace fuel tank]

Hi all

i need a replacement tank

23 litre old metal one
the old one

Found a nice stainless one

but wife won’t spend $400 🤯
the old one only needs a new cap as the breather valve has been painted over and won’t relieve pressure 
I don’t want a smaller tank as they are half the capacity and I like having more than less

I have heard that you can tighten the cap Halfway instead of full lock ,which would Let the fumes out but wife doesn’t like the idea of a loose cap

Any idea were I can get a used cap to fit the old tank

thanks

greg

[Boat trailers]

In the Newcastle area 

Felk trailers at Warner’s bay also

ISP at Glendale has all trailer parts you need to build your own trailer 

[Bonnet protector help]

Thanks zoran and rebel

i will chew the fat

 

[Bonnet protector help]

Hi

as this is a non fishing part

can I get opinions please on bonnet protectors 

I have a pearl white 200 cruiser with a polished alloy bar

i want a bonnet protector to protect the paint

looking at tinted Protector as I think it may stop a bit of glare at night when driving or just go clear

both same price $89

i don’t want to paint the back of the bull bar as I like it as it is
thanks

greg

[New reel- Fin Nor brand]

Thanks rebel 

I can’t wait to try it out ,I value going to a tackle shop and supporting the small shop owner you get good advice and in turn help keep them open

and skipper

i would give my eye teeth to have my dad alive to fish with ,I still have he’s old rods and can visualise him fishing so I know where your coming from

[New reel- Fin Nor brand]

Thanks

the tackle shop Dude was really amazed how much flex was in the rod when he checked it out
I am going to Port Macquarie in November so it’s going with me

[New reel- Fin Nor brand]

I bought a new reel today to go with my J/W Mundoo Rod

I found this rod in my Father in laws shed rafters Still in the J/W material cover 

The tackle shop at Charlestown recommended this after looking at the rod

cant wait to try it out

I was eyeing the Alvey SR Series but at $95 I couldn’t pass this up

 

[Casting a wooden reel]

Thanks Ryder 

I don’t think the mundoo has ever been used it was in the rafters covered in dust

i was tempted to replace the runners myself but I don’t want to stuff it up

my mate at Woy Woy is doing a 3 piece up for me but he doesn’t rush soi may not see the results for 6 months or more
I will drop you a message and get your mates name 

my better half thinks I waist-to much but it would be a nice Christmas present to my self to get the blank back to new

 

[Radio advice]

Thanks kingie 

I will check these threads

[Radio advice]

I pulled out the old 27 meg from the 1980,s as it was not working and had its day

i only go in Lake Macquarie and may venture in the channel out to moon island one day

what is better a vhf 25 watt unit to fit in the boat or just a neat little hand held 5 watt unit

the local boat store had a vast array

i liked the icom 25 and 35 They also had gme  hand held And some nice fit in boat units

i will average about 2 times a month going out so figure hand held unit better 
…wife does take her mobile as well (it’s part of her) But I like the idea of radio communication 

any advice appreciated 
thanks

greg