warnie100
-
Posts
72 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Events
Fishing Tips, Advice and Articles
Blogs
Store
Everything posted by warnie100
-
i have one as people have said just check it out but to answer your question what a gret boat at sea stable cuts water very well and very dry boat i have an old 85 evinrude on mine scaryquick but a good ride hope this helps
-
Thanks gazza done thatno difference
-
Thanks groper
-
Hi guys finally got the boat on the water butthe engine sputters and misses at idle any ideas of what causes this and it cuts out thanks in advance
-
Hi can anyone please tell me what the trail lock arm on my 76 85 hp actualy does and if is required thanks wayne
-
-
Hi guys can anyone tell me what gauge of wire to use on my trim motor the wires going into it have corroded badly and need replaceing thanks warnie
-
coils are fine may be the float level changed but there is fuel will try and check float level i believe they should be level but level with whati dont know
-
thanks leo yes spark but not sure of what the gap should be and the carbs din,t seem that dirty thanks warnie
-
Hi guys i am having trouble starting my 1976 85hp evinrude:1st it was starting fine until (1 i replaced the plugs i didnt change the gap from the box they came in)(2 i took carbys off and blew them out but dint remove the jets only the screw caps ) now turns with heaps of power but wont fire and there is plenty of fuel getting through any help is appreciated thanks wayne
-
thanks chrisg will look them up 1st thing
-
hi guys i have the tilt tube out of my 1976 evinrude 85 and was wondering if it is possible to get a piece of black or gal tube and have it milled down to size and threaded ,a mate has a lathe and i was quoted $160 + freight by a local dealer probably stainless i didnt ask after picking my jaw up off the floor but i dont think the old one was any thoughts ?
-
thanks gazza probably why it had a temp sensor just i havnt fitted it to the boat as yet still heaps to do and the temp gauge is stuffed will need replacing thanks warnie
-
thats a smart looking rig hpoe you catch heaps
-
thankyou craig you are a champion its been worrying the crap out of me asto what i was going to have to do thanks again
-
thanks guys will look it up
-
thanks craig i have got them all out bar one of the shock tubes which wont budge when you say cut it away do you mean cut through the shockie and do away with all together and what are they there for regards wayne
-
Hi guys does any one know where the water outlet is on a 1969 85 evinrude cant see a piddle hole to see if water pump is working
-
thanks guys will try the transmision and acetone but normal gas burner wont get enough heat in i tried today but will source someone with oxy thanks wayne
-
thanks gazza will try to get a heatsource today and i guess once you remove the locknut it would tap out
-
hope this works here are some pics and any help would be appreciated thanks warnie
-
-
will try to get some pics today and post thanks gazza
-
Hi guys i have removed the trim and tilt rams and motor but the swivel pins holding the motor are seized in the upper positon the top one has a thread and a lock nut and there seems to be a nut in the housing ,and the lower one holding the bottom of what looks like two shock absorbers is held in by split pins theseare the two areas that are seized /rusted is there anyone who can tell me how to get these out i have sprayed wd40 tapped them ect but no go regards wayne
-
Hi folks just aquired an 85hp v4 evinrude to fit my v150 nautiglass runabout can any one tell me how to find what year it would be please
