Aardvarking Posted October 20, 2017 Share Posted October 20, 2017 I was out fishing off a rock wall the other day, and I unfortunately took a bit of a tumble down the rocks and into the water. My fishermans instincts took effects instantly, and I dived into the water to retrieve the rod before it sank too deep, so luckily it will live to fish another day. Unfortunately, in the fall my reel came into contact with some rocks, leaving a few little dents in the lip. I am wondering if there is any way to repair the spool without being at risk of damaging the line every cast? There are a few other much smaller dents that were impossible to photograph with my low quality camera, but I didn't think they were too much of a concern. Be sure to correct me if I'm wrong and they do pose a problem. Link to comment Share on other sites More sharing options...
rickmarlin62 Posted October 20, 2017 Share Posted October 20, 2017 sand away any sharp edge with wetndry or a nail file then put a couple of layers of clear nail polish..rick Link to comment Share on other sites More sharing options...
blaxland Posted October 20, 2017 Share Posted October 20, 2017 (edited) I have used very fine emery paper to finish after using a whet stone havent thought of the nail polish but will give it a try Edited October 20, 2017 by blaxland Link to comment Share on other sites More sharing options...
savit Posted October 20, 2017 Share Posted October 20, 2017 The issue is usually for casting braid and not so much for mono. Link to comment Share on other sites More sharing options...
Aardvarking Posted October 20, 2017 Author Share Posted October 20, 2017 Just now, savit said: The issue is usually for casting braid and not so much for mono. Yeah, I know. I took off the braid and left on the mono backing, because I didn't want to damage the braid during the repair process. Link to comment Share on other sites More sharing options...
Aardvarking Posted October 20, 2017 Author Share Posted October 20, 2017 Thanks for the tips. I filed down the area with a nail file, then added an extremely thin coat of nail polish. I waited for it to set and then added another thicker layer of nail polish, using a tissue to get it as smooth as possible. I then lightly wet sanded that down with some 240 grit sandpaper, and now it's good to go. I ran my finger along the rim, and I genuinely couldn't find where the dent was before with my finger, it's good as new. Link to comment Share on other sites More sharing options...
rickmarlin62 Posted October 20, 2017 Share Posted October 20, 2017 I love it when a plan comes together...rick Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now