Welster Posted June 3, 2019 Share Posted June 3, 2019 (edited) I have the Telwater scuppers with the squash ball in them and had no issue at all. The older version with the stupid rubber flap on my previous boat just did not work and the dealer didn’t even attempt to fix them under warranty after asking at service time. We sealed them up. Edited June 3, 2019 by Welster Typo again 1 Link to comment Share on other sites More sharing options...
Basil D Posted August 7, 2019 Share Posted August 7, 2019 Have you had any problems with water getting under the floor while out fishing, Im getting a few litres in a day Link to comment Share on other sites More sharing options...
Welster Posted August 7, 2019 Share Posted August 7, 2019 4 minutes ago, Basil D said: Have you had any problems with water getting under the floor while out fishing, Im getting a few litres in a day The last few trips I have had a few litres as well. I had doubts if it happened out on the water though. It’s definitely drained atm as I washed the boat at a mates house before driving home with the bungs out and putting it in the garage. So I will know for sure next trip. My boat is an Stacer Easy Rider not a Trident. 1 Link to comment Share on other sites More sharing options...
jeffb5.8 Posted August 8, 2019 Share Posted August 8, 2019 I get that and just put it down to not having enough tilt to drain water from the very front, might have to try and reverse down the boat ramp and leave the bung out and see if more water comes out before I go fishing. I did taste it once and it was fresh so I put it down to being rain water rather than through my scupper Link to comment Share on other sites More sharing options...
Basil D Posted August 29, 2019 Share Posted August 29, 2019 ok so I removed everything out of the back, foam and all and took her out, found minor droplets from the trim tabs and a split hose from the return hose of the live bait tank, also washed the deck and found water leaking from behind the funnels that drain the water to the back scuppers , all minor stuff but annoying, resealed the lot and replaced hoses with high pressure hoses, I know they wont split 1 Link to comment Share on other sites More sharing options...
Welster Posted August 29, 2019 Share Posted August 29, 2019 Good move on using pressure hose it should be that way from the factory. Link to comment Share on other sites More sharing options...
noelm Posted August 29, 2019 Share Posted August 29, 2019 It might be prudent to protect the hoses and electrical wiring from the edges of the "ribs" on the floor while you have access to prevent possible damage later on. Link to comment Share on other sites More sharing options...
jeffb5.8 Posted August 29, 2019 Share Posted August 29, 2019 Basil was getting the floor out a big painful job ? Link to comment Share on other sites More sharing options...
Basil D Posted August 30, 2019 Share Posted August 30, 2019 10 hours ago, jeffb5.8 said: Basil was getting the floor out a big painful job ? That was the easy part, the hard part was stacking all the foam back in LOL 13 hours ago, Welster said: Good move on using pressure hose it should be that way from the factory. cant believe that it wasn't 12 hours ago, noelm said: It might be prudent to protect the hoses and electrical wiring from the edges of the "ribs" on the floor while you have access to prevent possible damage later on. I have padded them nicely 1 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now